Search found 111 matches

by 4cambob
Sun Aug 28, 2022 3:47 pm
Forum: Technical Discussions
Topic: removing brake master cylinder
Replies: 7
Views: 1679

removing brake master cylinder

Has anyone removed the brake master cylinder on a 2l coupe and if so do I need to completely remove the whole dash and separate all the instrument wirings first as well as the need to remove the clutch master cylinder ?. My car has the cast iron master cylinder if that makes any difference. I cant s...
by 4cambob
Mon Jul 25, 2022 8:33 pm
Forum: Technical Discussions
Topic: Brake master cylinder workings
Replies: 0
Views: 1195

Brake master cylinder workings

On my 2l coupe I removed the two pistons and replaced the seals on my master cylinder as the bore seemed perfect but the rear brakes were not working, but I cant figure out if something is amiss with the master cylinder. When I installed the second piston it had to be done against the resistance of ...
by 4cambob
Sat May 29, 2021 6:04 am
Forum: Technical Discussions
Topic: Common Parts
Replies: 7
Views: 3838

Re: Common Parts

This list would be a great help as tbere are indeed many parts shared with other models and makes.
by 4cambob
Thu May 20, 2021 10:17 am
Forum: Technical Discussions
Topic: Seat belts for 1967 Dino coupe
Replies: 11
Views: 5355

Re: Seat belts for 1967 Dino coupe

I posted a question before about the b pillar mounting points, and my car also being a 67 has never had them so that may also be the case wirh yours.
by 4cambob
Sun Feb 28, 2021 9:19 pm
Forum: Technical Discussions
Topic: Where can I get these parts
Replies: 9
Views: 9479

Re: Where can I get these parts

Hi Ben. Can you post some details of the urethane softener and the hard black urethane that you mentioned as I would like to experiment in making certain parts.
by 4cambob
Wed Feb 24, 2021 8:53 pm
Forum: Technical Discussions
Topic: Where can I get these parts
Replies: 9
Views: 9479

Re: Where can I get these parts

I never found these parts. The bonnet release rubber in the photo is my own attempt at manufacture .
by 4cambob
Sun Feb 07, 2021 9:28 pm
Forum: Technical Discussions
Topic: Fuel Door Flap.
Replies: 9
Views: 6368

Re: Fuel Door Flap.

There should be a spring , which fits on the lower bracket. I will try and get a photo if possible.
by 4cambob
Sat Feb 06, 2021 8:54 pm
Forum: Technical Discussions
Topic: Mystery bumper gaskets Dino coupe 2000
Replies: 5
Views: 3807

Re: Mystery bumper gaskets Dino coupe 2000

The recess in the gasket prevents it from moving . If you really wanted you could put a dab of contact adhesive between the gasket and bumper. That is what was also used to hold on the rubber boot seal, the front wing rear seal,the sill seals and door jam seal.
by 4cambob
Sat Feb 06, 2021 10:28 am
Forum: Technical Discussions
Topic: Mystery bumper gaskets Dino coupe 2000
Replies: 5
Views: 3807

Re: Mystery bumper gaskets Dino coupe 2000

You should tape up the wing area then trial fit the bumper to make sure there is a tiny gap.,when satisfied then refit with the rubber end gaskets. If you have compression this will eventually lead to the bumper splitting the gasket.