Fiat Dino Forum (FDF)

Thanks Vravolta. My understanding for the round vents next to parcel shelf is like yours, however there is much more to all this. Those round vents have a channel in the bodywork going forward which finishes in a circular lip approximately 2 inch wide which I assume by looking at the diagram would t...

Thank you Dinoswede, much appreciated.

If you look at the photo,its the bracket in top centre where the red wire goes. This is under the dash just left of the steering wheel and very close to the interior light,which makes me doubt if it would be for another interior light.

I think that is a good result considering what the car would need to bring it to a good original condition. I would guess that maybe having the 2.4 engine played a part.

I am taking about the rear interior vents that also house the rear window operating round knob and interior light,on a 2.0 at least. The space behind that vent is open to the boot area and to inside the sills as far as I am aware.

Thanks for the link Mike. However the only seal I could see was the upper seal which I do not need. Do you have the relevant part number .

Thanks Scalino and Tobi. The Cicognani site only sells it as a set of which I do not recognise two of the included seals. The Dinoparts set seems better but they don't sell it separately . One possibility is the door shut seal on a 246 gt dino which I can buy on its own but I am not sure if it's ide...

Does anyone know where I can buy the small door seal for the 2lt coupe. The one that goes on the trailing edge of the front wings,also the door shut and below the Bertone stainless sill trim. It has a D section of 10mm.

I am just finishing my body restoration and not yet got round to the mechanical, so I don't know of a shock rebuilder. If I get stuck I will do them myself.

Could you not get your original ones rebuilt as they seem to come apart easily and would only need some seals and new oil.