Search found 111 matches

by 4cambob
Wed Oct 10, 2018 8:46 am
Forum: Technical Discussions
Topic: wiper motor removal
Replies: 8
Views: 7164

Re: wiper motor removal

Like I said it does not have a white connection block,the wire come from the main loom and are soldered to the rear of the motor,similar to this photo.
by 4cambob
Tue Oct 09, 2018 3:50 pm
Forum: Technical Discussions
Topic: wiper motor removal
Replies: 8
Views: 7164

wiper motor removal

Does any one know how to remove the wiper motor on a coupe without un-soldering the wires.The wires are soldered on within a plastic cover on the end of the motor. There is no other connection joint I can see for these and they then pass into the wiring loom underneath the front wing.
by 4cambob
Wed Oct 03, 2018 5:46 pm
Forum: Technical Discussions
Topic: 2.0 Coupe Inner Arches
Replies: 3
Views: 3857

Re: 2.0 Coupe Inner Arches

Just for comparison this is mine after extensive repairs.
by 4cambob
Wed Oct 03, 2018 5:39 pm
Forum: Technical Discussions
Topic: 2.0 Coupe Inner Arches
Replies: 3
Views: 3857

Re: 2.0 Coupe Inner Arches

Its the build up of grime,dirt and sludge in these areas which retains water once you drive in the rain which leads to rust. The cars never had a liner but this would be an ideal solution.
by 4cambob
Sun Jul 22, 2018 1:13 pm
Forum: Technical Discussions
Topic: Boot lid/trunk rubber bump stops for coupe
Replies: 0
Views: 3337

Boot lid/trunk rubber bump stops for coupe

Does any one know if these (4 off) should be domed or flat top and the same goes for the two inside the fuel flap (are they the same). Could these be the ones from https://www.fiat500ricambi.com
RB1020 or RB1021
by 4cambob
Fri Jul 13, 2018 8:36 am
Forum: Market
Topic: Dinoplex AEC101 cases
Replies: 8
Views: 9040

Re: Dinoplex AEC101 cases

wow ,very impressive work.
by 4cambob
Sun Jun 17, 2018 7:58 pm
Forum: Technical Discussions
Topic: Chain tensioner adjustment, turned in to major failure
Replies: 76
Views: 55183

Re: Chain tensioner adjustment, turned in to major failure

Sorry to hear about your misfortune. If the chain did not jump a tooth then I would guess that being a low miles original car it would still have the sodium exhaust valves and these have been known to break, apparently at almost any revs. Either way its going to be quite a rebuild.
by 4cambob
Fri May 18, 2018 9:56 pm
Forum: The Fiat Dino
Topic: coupe values
Replies: 5
Views: 6804

Re: coupe values

I would say not. To make a fair rarity comparison you would need to compare one model versus another, not against a whole model range from a manufacturer.
by 4cambob
Tue Apr 17, 2018 8:19 am
Forum: Market
Topic: Wanted: several parts 2000 Coupé
Replies: 3
Views: 5041

Re: Wanted: several parts 2000 Coupé

a rear licence plate frame,not sure if correct
https://www.ebay.co.uk/itm/plaque-arrie ... Sw~HBaNrFA
by 4cambob
Fri Apr 13, 2018 11:55 am
Forum: The Fiat Dino
Topic: coupe values
Replies: 5
Views: 6804

Re: coupe values

Well on this site https://www.autoscout24.com/ there are 22 fiat dino coupes between 54,500 - 73,900 euros. On the same site I counted 400 and yes that is correct,non mondial ferraris between 28,500 - 73,900 euros, and there is a lot of very tasty low mileage cars in that range,including 612`s,360`s...