Search found 111 matches
- Wed Oct 10, 2018 8:46 am
- Forum: Technical Discussions
- Topic: wiper motor removal
- Replies: 8
- Views: 7219
Re: wiper motor removal
Like I said it does not have a white connection block,the wire come from the main loom and are soldered to the rear of the motor,similar to this photo.
- Tue Oct 09, 2018 3:50 pm
- Forum: Technical Discussions
- Topic: wiper motor removal
- Replies: 8
- Views: 7219
wiper motor removal
Does any one know how to remove the wiper motor on a coupe without un-soldering the wires.The wires are soldered on within a plastic cover on the end of the motor. There is no other connection joint I can see for these and they then pass into the wiring loom underneath the front wing.
- Wed Oct 03, 2018 5:46 pm
- Forum: Technical Discussions
- Topic: 2.0 Coupe Inner Arches
- Replies: 3
- Views: 3900
Re: 2.0 Coupe Inner Arches
Just for comparison this is mine after extensive repairs.
- Wed Oct 03, 2018 5:39 pm
- Forum: Technical Discussions
- Topic: 2.0 Coupe Inner Arches
- Replies: 3
- Views: 3900
Re: 2.0 Coupe Inner Arches
Its the build up of grime,dirt and sludge in these areas which retains water once you drive in the rain which leads to rust. The cars never had a liner but this would be an ideal solution.
- Sun Jul 22, 2018 1:13 pm
- Forum: Technical Discussions
- Topic: Boot lid/trunk rubber bump stops for coupe
- Replies: 0
- Views: 3350
Boot lid/trunk rubber bump stops for coupe
Does any one know if these (4 off) should be domed or flat top and the same goes for the two inside the fuel flap (are they the same). Could these be the ones from https://www.fiat500ricambi.com
RB1020 or RB1021
RB1020 or RB1021
- Fri Jul 13, 2018 8:36 am
- Forum: Market
- Topic: Dinoplex AEC101 cases
- Replies: 8
- Views: 9117
Re: Dinoplex AEC101 cases
wow ,very impressive work.
- Sun Jun 17, 2018 7:58 pm
- Forum: Technical Discussions
- Topic: Chain tensioner adjustment, turned in to major failure
- Replies: 76
- Views: 55539
Re: Chain tensioner adjustment, turned in to major failure
Sorry to hear about your misfortune. If the chain did not jump a tooth then I would guess that being a low miles original car it would still have the sodium exhaust valves and these have been known to break, apparently at almost any revs. Either way its going to be quite a rebuild.
- Fri May 18, 2018 9:56 pm
- Forum: The Fiat Dino
- Topic: coupe values
- Replies: 5
- Views: 6916
Re: coupe values
I would say not. To make a fair rarity comparison you would need to compare one model versus another, not against a whole model range from a manufacturer.
- Tue Apr 17, 2018 8:19 am
- Forum: Market
- Topic: Wanted: several parts 2000 Coupé
- Replies: 3
- Views: 5091
Re: Wanted: several parts 2000 Coupé
a rear licence plate frame,not sure if correct
https://www.ebay.co.uk/itm/plaque-arrie ... Sw~HBaNrFA
https://www.ebay.co.uk/itm/plaque-arrie ... Sw~HBaNrFA
- Fri Apr 13, 2018 11:55 am
- Forum: The Fiat Dino
- Topic: coupe values
- Replies: 5
- Views: 6916
Re: coupe values
Well on this site https://www.autoscout24.com/ there are 22 fiat dino coupes between 54,500 - 73,900 euros. On the same site I counted 400 and yes that is correct,non mondial ferraris between 28,500 - 73,900 euros, and there is a lot of very tasty low mileage cars in that range,including 612`s,360`s...