New member introduction

Discussions and Socializing

Moderators: Philt68, doublegarage

Re: New member introduction

Postby Scalino » Sat May 05, 2018 3:07 pm

Well, it's weeping from the plug in the top of the filter housing (100% sure) on two carbs. We 'fixed' it by putting some fuel resistant Locktight on it. Is it a professional solution? Well no, but it works. We'll keep a very close eye on it, but for now it seems to work. Now, it may not have been much of a leak, but any fuel leak is too much in my eyes.

Now all throats are synchronised and the idle mixture set, it runs very well I would say, a massive improvement pre carb overhaul. :D

Slight bummer, the battery isn't charging, so we'll have a look at that now...
Scalino
 
Posts: 49
Joined: Mon Jul 24, 2017 7:22 pm
Location: The Netherlands
Dino: Fiat Dino 2.4 Spider

Re: New member introduction

Postby Scalino » Sun May 13, 2018 9:29 am

Well, I was an idiot :lol:. The plug with the yellow and grey wire wasn't plugged in. To my defence, one end is actually a plug, but on the other side they didn't bother to put the right connectors for a plug on, hence there is no plug on that end. Not a great description I know ;). Generally the wiring is just a mess, so it isn't immediately obvious when there is a loose connector... :|

Conclusion, all is working as it should, for now at least :roll:
Scalino
 
Posts: 49
Joined: Mon Jul 24, 2017 7:22 pm
Location: The Netherlands
Dino: Fiat Dino 2.4 Spider

Previous

Return to The Garage

Who is online

Users browsing this forum: No registered users and 3 guests