Page 1 of 1
How do I remove trim Dino coupe 2000?
Posted: Mon Jan 25, 2021 1:14 am
by bhiggins2
I need to make a repair to the lower section of the front wing panel on my coupe, above the front right jack point. I would like to remove the stainless steel rocker trim. Can anyone tell me how to go about removing this piece of trim? Thanks, Ben.
Re: How do I remove trim Dino coupe 2000?
Posted: Tue Jan 26, 2021 9:52 pm
by 4cambob
I would use a thin wide metal spatula and slide it between the bodywork and trim ,note there are two clips within that you must avoid,then gently ease the trim off. Do not use screwdiver or similar as this will mark the paint and trim.
- big--578e30dd.jpg (13.1 KiB) Viewed 2598 times
Re: How do I remove trim Dino coupe 2000?
Posted: Wed Jan 27, 2021 2:54 am
by bhiggins2
Can anyone point me to what the trim clips look like?
Thanks, Ben.
Re: How do I remove trim Dino coupe 2000?
Posted: Wed Jan 27, 2021 9:15 am
by 4cambob
Re: How do I remove trim Dino coupe 2000?
Posted: Wed Jan 27, 2021 8:57 pm
by bhiggins2
Thanks. That is helpful to know I am dealing with a round plastic clip below the trim. Ben.