Fiat Dino Forum (FDF)

The original label plates on my Dinoplex are completely illegible. I purchased the reproduction labels from Superformance and the one label plate is too long and the holes don't line up with the mounting pegs on the Dinoplex cover. Has anyone else run into this problem? The text portion is fine, but the border part is too large. I could scan, re-size with software, print out on etch resist and etch a proper sized aluminm plate, but wanted to see if there was a quicker alternative without chiseling off the mounting pegs on the Dinoplex and recreating them with something that is glued on to "look proper". I took a small file and reduced the mounting pegs down so they fit the holes of the old & new plates without distortion. Ben.

For that exact reason i made them myself. Also the red/black border is incorrect with the SF plates.
The ones i made, i made them with only a marker for the holes so that i could drill the holes myself at the correct place.
I might still have one set left, let me know if you are interested.

Realize this is an older post. But im in the process of retrofitting the Dinoplex to my early 2000 Spider.

Stefan - Do you still have the reproduction labels available? I’m in Orlando Florida

Yes i have them, you can find them here:
https://www.elshoutengineering.com/fiat-dino-parts