Fiat Dino Forum (FDF)

My car's A-pillars have the main piece of stainless attached to the body, but are missing the smaller stainless-steel piece that retains the thin rubber blade.

Therefore, I'm looking for these narrow pieces that attach the thin rubber seal to the A-pillar.

Thanks,

-Richard

Have a look on eBay, Article number: 152101405180

"Open the driver's door on your Fiat Dino Coupe, and look for a Stainless Steel trim piece that extends on the exterior of the A-Pillar from the front window height to the roof line.
See the attached picture for the location. This trim piece comes with the rubber gasket and the metal holding piece as well, all in near perfect condition. No nicks, dents, or dings. "

Yes, saw that - just wondering if anybody had the retainer strip alone.

Thanks Thomas.

Never mind - I attached the rubber strip with some 3M 38583 exterior attachment tape - the good stuff. I've probably slammed the door 50 times today and it's still attached.

I always seem to have trouble using 3M weatherstrip adhesive - but always have success with this tape.

Thanks,

-Richard

replying again to my own post here in the hope that someone has these little stainless rails that hold a rubber strip on the Fiat Dino Coupe doorframe. Trying to stop the amazing wind noise I get on the driver's side.

If anyone could take some good pictures of how the weatherstripping is arranged/attached above the door-hinge area (i.e. below the quarterlight) that would be great.

Thanks,

-Richard

Hi Richard,

I have this small stainless steel part

Regards Alfredino

Over a year ago, Alfredino found me this piece for the driver's (Left) side of the car - still looking for the same piece for the Right side. I just had the passenger door in 100 pieces to renew the window channel and all the other door rubber - therefore it exposed that I'm missing this small stainless strip and the little blade of rubber that should be fitted to it.

Does anybody have one?

Thanks,

-Richard