Fiat Dino Forum (FDF)

if you look at the picture,the top left is a complete unit,bottom left is the whole rotating top half (made of two parts) as viewed upside down,top right is what you have,bottom right is the same as bottom left except its the top view and without the central spindle which can be seen in top left picture.hope this helps. You should be able to buy them used but beware some unrealistic asking prices.

Reviving an old thread.

The rear vents on my 2400 Coupe were looking a bit tired. I have a new 3D Printer so I thought I'd try to reproduce them. They turned out okay - if anybody would like the file to print their own then let me know.

I didn't have any red filament to make the red Nike-swoosh under the knob. hence green. They're probably also a bit too "appliance-white" so could use a coat of paint.

-Richard

Hi Richard,

I send you a PM for the 3d files.
Can you check please?

Thanks.

Hello,

I see some PM messages asking for the 3D files - unfortunately the PM system isn't working for me and my replies are stuck in "outbox'.

If you email me at srlane61<at>gmail<punto>com then I will try to reply there.

Thanks,

-Richard